Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)ġ2. Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor¡¯s rated voltage to achieve higher step ratesġ0.
But basically Im trying to use the(see the bottom of this page for more information)ĩ. 1 So Im pretty brand new to Arduinos in general so I do apologize if its a simple mistake.
Arduino stepper motor shield cnc driver#
Module size, pinout, and interface match those of our A4988 stepper motor driver carriers in most respects Exposed solderable ground pad below the driver IC on the bottom of the PCBĨ. 4-layer, 2 oz copper PCB for improved heat dissipationħ. Short-to-ground and shorted-load protectionĦ. Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockoutĥ. Can interface directly with 3.3 V and 5 V systemsĤ.
Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-stepģ. Simple step and direction control interfaceĢ. When you place the heatsink on the chip, make sure that the heatsink don’t touch any other pins or electronics or they will break! We have no warranties on electronics since it’s out of our control once it leaves our facilities.ġ. That’s how you need to mount these drivers. Look at the picture and notice the small screw (potentiometer) and see what way its pointing. Important! These steppers must be mounted the correct way. If you need a stronger machine, then upgrade to these steppers. These steppers are much stronger than A4988 steppers that is included in the standard Arduino kit. Shield type: Arduino Nano Firmware: GRBL Modular stepper motor drivers: 3 Limit switches: 6 Micro-stepping: 1/16 Coolant enable Uses removable Pololu.
0 kommentar(er)
